Recommended accessories

6,4mm Angled connector piece made from plastics for PVC, PU, PA silicone or PE with an inner diameter of 6,4mm, equipped with a G1/4" outer thread.

Note for watercooling beginners:
The connectors for hoses(7/16", 3/8",1/2") are provided with measurements in mm in our shop. These can differ by +-1mm, which is no problem as hose clamps have to be used for installation. If the hose is to be mounted without a clamp, a larger fitting should be chosen. With some fittings that tend to be larger, it is possible though that a hose with an inner diameter of 13mm actually does seal without a hose clamp.

Note: Due to the longer outer thread of the colored hose fittings some connector may require spacer rings to be compatible. (Product No.: 14087 or 14151). the thread can also be shortened at aour own responsibility with a fine saw.

Important: the fitting is not equipped with an O-ring seal, to ensure tight seal we recommend Teflon tape (Product. No.: 32002)